Descargar Imprimir esta página

Graco 254968 Operacion página 3

Pulverizadores eléctricos sin aire
Ocultar thumbs Ver también para 254968:

Publicidad

Warning
The following warnings are for the setup, use, grounding, maintenance and repair of this equipment. The exclamation
point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risks. Refer back to
these warnings. Additional, product-specific warnings may be found throughout the body of this manual where appli-
cable.
Grounding Instructions
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with
an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
GROUNDING
Improper installation of the grounding plug is able to result in a risk of electric shock.
When repair or replacement of the cord or plug is required, do not connect the grounding wire to
either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow stripes is the
grounding wire.
Check with a qualified electrician or serviceman when the grounding instructions are not completely
understood, or when in doubt as to whether the product is properly grounded.
Do not modify the plug provided; if it does not fit the outlet, have the proper outlet installed by a qual-
ified electrician.
This product is for use on a nominal 120V circuit and has a grounding plug similar to the plug illus-
trated in the figure below.
Only connect the product to an outlet having the same configuration as the plug.
Do not use an adapter with this product.
Extension Cords:
Use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot receptacle that
accepts the plug on the product.
Make sure your extension cord is not damaged. If an extension cord is necessary, use 12 AWG
2
(2.5 mm
An undersized cord results in a drop in line voltage and loss of power and overheating.
311732B
All manuals and user guides at all-guides.com
) minimum to carry the current that the product draws.
WARNING
Warning
3

Publicidad

loading

Este manual también es adecuado para:

390sts2533583902549692539612554988 ... Mostrar todo