Publicidad
Idiomas disponibles
Idiomas disponibles
1. Place the supporting base in the rotating screw on the
cutting accessories holder (17);
2. Insert a hex key or a screwdriver in the supporting base
hole and in the cutting accessories support hole to lock
the rotating screw;
3. Tighten the nylon cutting-line head in the thread of the
rotating accessory counter clockwise;
4. Remove the wrench from the accessories holder.
1. Press the fixing tabs and remove the cutting head cover;
2. Remove the spool from the cutting head and remove the
line;
3. Prepare about 5m of nylon line and fold it in half.
4. Insert the line in the spool holes making sure that they
have the same length in both sides;
5. Roll both extremities in parallel, one in each side of the
middle tab, clockwise (as the arrow on the bottom of the
spool);
6. Insert the spool in the cutting head and fix both
extremities in the fixing notches;
7. Insert the cover fixing tabs in the cutting head. Make sure
the cover is well tightened.
1. Pull and rotate the fixing spring of the rotating shaft tube;
2. Insert the rotating shaft tube (4) in the control handle.
Simultaneously, fit the rotating shaft in the control
handle shaft's hole;
3. Rotate the rotating shaft tube so the fixing hole gets
aligned with the fixing spring pin;
4. Rotate and loose the fixing spring;
5. Pull the rotating shaft tube to ensure that it is well
tightened;
6. Tighten the rotating shaft fixing nut.
1. Install the backpack (13) in the support structure (6);
2. Tighten the fixing straps (5) in the support structure;
3. Adjust the length of the transportation straps in a way the
equipment's weight is equal on both shoulders.
When using the machine, you should take into
consideration some care and procedures of use in order to
avoid accidents, damage and to increase the efficiency of
the machine:
▪ Ensure that the machine is started at a distance of more
than 3m from the supply local;
▪ Always hold the machine with both hands and keep it on
the right side of your body;
▪ Keep the cutting accessories below waist level, thus
reducing the risk of being hit by projected objects during
operation;
▪ Do not use the machine to cut branches or logs or wood.
If you try to cut logs above the recommended size, the
machine may regress and cause accidents to the user;
▪ When the machine is on idle speed, the cutting
accessory is not rotating. Otherwise, contact technical
assistance to make an inspection and solve the problem;
▪ If you hear an unusual noise or the brush cutter vibrate
abnormally, stop working and identify the cause;
▪ Never use the machine without the protection of the cut
accessories placed or damaged.
1. Rotate the air inlet regulating button counter clockwise
to close the air;
If the engine is warm or the air temperature is high, do not
close the air control valve.
2. Press the carburetor pump several times until the pump
is full with gasoline. Check if the fuel tube is full; in that
time, the carburetor has fuel;
3. Set the "ON/OFF" switch in (I) position;
4. Hold the machine with one hand and pull the starter grip.
Pull slowly until feel some resistance and then pull
quicker until the engine starts running;
5. After the engine starts, the tool is on at idle speed;
6. After a few seconds, open the air. Rotate the air inlet
regulating button clockwise;
When the starter handle returns to the original
position, the hand and arm can be moved quickly
towards the combustion engine.
Let the engine warm up at idle speed for a few
seconds before using it.
Publicidad
