Publicidad
Idiomas disponibles
Idiomas disponibles
Cut the power supply cable after disconnecting it from the mains
when you decide not to use the appliance any longer.
The manufacturer may not be held responsible for any damage due to:
Incorrect installation, improper, incorrect and irrational use.
Installation
Only a qualified person in compliance with the instructions provided must install the
appliance. Johnson declines all responsibility for improper installation, which may harm
persons and animals and damage property.
Important:
- The power supply to the appliance must be cut off before any adjustments or maintenan-
ce work is done on it;
- Air duct is supposed to use in ventilation.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it
must be appropriate. The figure below gives the dimensions of the cut-out for installation
under the counter or in a wall cabinet unit.
Note: Installation in compliance with the consumption declaration. In order to ensure
adequate ventilation, the back panel of the cabinet unit must be removed. Installing the
oven so that it rests on two strips of wood is preferable. If the oven rests on a continuous,
flat surface, there must be an aperture of at least 45×560mm .
The panels of the adjacent cabinets must be made of heat-resistant material. In particular,
cabinets with a veneer exterior must be assembled with glues which can withstand
temperatures of up to 100ºC.
In compliance with current safety standards, contact with the electrical parts of the oven
must not be possible once it has been installed.
All parts, which ensure the safe operation of the appliance, must be removable only with
the aid of a tool.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the
4 wooden screws into the 4 holes located on the perimeter of the frame.
11
V.1
Publicidad
