Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Cleaning and Care
Empty the water container
1. Pull out and hold the water
container with two hands.
2. Tilt the water container, pour
out the condensate water into
the basin.
3. Install the water container.
Warning!
！
Empty the water container after each use. Once the water
container is filled completely, the programme will be paused
and the "
dryer can be restarted by pressing Start/Pause button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.
Clean the filters
Leave the dryer to cool down.
1. Open the door.
2. Take out the door filter.
3. Open the filter and remove
the fluff on the filter, You can
clean it in running water.
4. Dry the door filter thoroughly
before installing it back.
Take notice of the correct orientation
before inserting the door filter.
Note!
The lint filter accumulated on the filter will block the air circulation, which will
cause the extension of drying time and energy use; therefore, the scrap thread
filter shall be cleaned after each use.
Do disconnect the power cord before cleaning!
Do not operate the dryer without the lint filter!
Clean the lint filter after each use to prevent lint accumulation inside the dryer.
" icon will light. After the container is emptied, the
22
V.2
Publicidad
