Parkside PBH 1050 D4 Instrucciones De Utilización Y De Seguridad página 31

˜ Setting the rotation direction
NOTE
Operate the rotation direction switch
u
only when the product is at a standstill.
Use the rotation direction switch to change
o
the direction of rotation of the power tool. This
is not possible while the on/off switch
pressed in.
Clockwise: Push the rotation direction switch
o
to the left as far as the stop.
Anti-clockwise: Push the rotation direction
o
switch to the right as far as the stop.
˜ Switching on/off
Insert the mains plug
o
The LED lights up to indicate that the
6 ] [
product is ready for use.
Switching on
Press the on/off switch
o
Do not switch the power tool on unless you
o
plan to use it, to save energy.
Switching off
Release the on/off switch
o
At low temperatures, the power tool will only
o
reach its full hammer performance/strike
power after a certain time.
Continuous operation
Press the on/off switch
o
press the lock button
switch.
To cancel continuous operation, press the on/
o
off switch and release it.
3 ] [
[ 2 ]
is
[ 3 ]
into a socket-outlet.
5 ] [
.
3 ] [
.
3 ] [
. At the same time,
[ 3 ]
to lock the on/off
[ 4 ]
˜ Selecting rotational speed
NOTE
The set speed is only reached in continuous
u
operation.
Rotate the speed selection wheel
o
the rotational speed from level 1 (low) to level
6 (high). The required speed depends on the
material to be processed.
˜ Troubleshooting
Problem Possible
cause
The product The motor is
does not defective.
work.
The Excessive
performance pressure on
of the the product.
product is
poor.
The drill
chuck grease
is used up.
˜ Cleaning and maintenance
m WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments, cleaning and when not
in use.
to select
7 ] [
Solution
Have the
product
repaired by
a qualified
specialist.
Apply
appropriate
pressure to the
product.
Lightly grease
the SDS-Plus
tool holder
[ ]
with drill chuck
grease.
GB/IE 31