Publicidad
Idiomas disponibles
Idiomas disponibles
VENTILATOR MODE
•
After the fan mode has been selected with the remote control, the wind indicator lights up.
•
Press the speed button to select between the speed levels High/Medium/Low.
The temperature cannot be adjusted.
DEHUMIDIFICATION MODE
In dry mode, the dry indicator light is activated.
Remove the water plug on the back of the appliance as shown in the
illustration. Insert the water pipe (not supplied) and place the other end
in a water tank or drain.
In dry mode, the compressor starts when the room temperature is higher
than ≥17℃ (63℉). The compressor follows the following rules:
•
When the room temperature is ≤15℃ (59℉), the compressor is
switched off.
•
When the room temperature is ≥17℃ (63℉), the compressor is
restarted. (The restart takes place after three minutes due to the
protective function).
In dry mode, the fan runs at low speed by default and the wind speed cannot be adjusted.
The temperature cannot be adjusted.
Note: The exhaust pipe should be removed in dry mode as this may affect performance and the "FL"
water level alarm light will illuminate.
HEATING MODE
•
After selecting the heating mode by the remote control, the wind indicator lights up.
•
Press the up/down button to adjust the set temperature from 16°C to 30°C.
•
Press the speed button to select between high/medium/low speed.
TIMER MODE
•
In standby mode, press the timer button to set the switch-on time. Press the up and down buttons
to set between 0 and 24 hours and the timer indicator lights up.
•
After the air conditioner is switched on, press the timer button to set the switch-off time. Press the
up and down buttons to set between 0 and 24 hours and the timer indicator lights up.
161
Symbolic
image
Publicidad
