Publicidad
Idiomas disponibles
Idiomas disponibles
EMPTY WATER TANK MANUALLY
The unit has an automatic water evaporation system. The circulation of the condensed water cools the
compressor, which not only improves the cooling performance but also saves energy.
If the water tank is still full, "FL" appears on the control panel display and the air conditioner switches off
automatically. The unit is locked until the water tank is emptied.
To empty the condensation water tank, follow the steps
1. Pull the mains plug
2. Place a collecting vessel under the condensation water outlet at the back
of the appliance, carefully remove the cap from the outlet and allow the
water to drain into the collecting vessel.
3. At the end, you can tilt the air conditioner slightly - but not more than 30°.
4. Once the tank is completely empty, carefully reinsert the plug into the
water outlet.
5. Plug in the mains plug and restart the unit.
ACTIVITIES AT THE BEGINNING/END OF THE SEASON
END OF SEASON ACTIVITIES
•
Carefully empty the condensation water tank completely into a suitable container as described in
the section "Emptying the water tank".
•
Run the air conditioner in fan mode for 2 hours until the unit is completely dry inside.
•
Switch off the unit and disconnect the mains plug.
•
Clean the filter and push it back in after it has dried (see section "Cleaning the air filter").
•
Remove the exhaust hose and accessories and stow them carefully.
•
Remove the batteries from the remote control
•
Pack the unit and store it in a cool, dry place.
CONTROLS AT THE BEGINNING OF THE SEASON
•
Check that the power supply cable and the socket are in order and that the earthing is functional.
•
Make sure that the plug is carefully fitted in the condensation water outlet and that the filters are
inserted.
•
Follow the installation and safety instructions carefully.
out
of the socket.
below:
163
Symbolic
image
Publicidad
