Publicidad
Idiomas disponibles
Idiomas disponibles
Additional safety notices
Use only adhesive signs to label the power
tool. Do not drill any holes into the housing.
The mains voltage must match the voltage
specification on the factory plate.
Noise and vibration
NOTE
Values for the A
rated noise level as well as
-
the total values pertaining to vibration can
be gleaned from the "Technical data" table.
The noise and vibration values have been
determined in accordance with EN 62841.
WARNING!
The specified measured values apply to
new power tools. Daily use causes the noise
and vibration values to change.
NOTE
The vibration emission level stated in these
instructions has been measured in
accordance with a standardised test given
in EN 62841 and may be used to compare
one tool with another.
It can also be used for a preliminary
assessment of exposure. The declared
vibration emission level represents the main
applications of the tool.
However, if the tool is used for different
applications, with different accessories or
poor maintenance, the vibration emission
level may differ. This may significantly
increase the exposure level over the total
working period.
However if the tool is used for different
applications, with different accessories or is
poorly maintained, the vibration emission
may differ. This may significantly decrease
the exposure level over the total working
period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: Maintain the power tool and accessories,
keep hands warm, organise work patterns.
CAUTION!
Wear ear defenders at a sound pressure
level above 85 dB(A).
18
VLP 18
Publicidad
