Orbegozo SFA 6600 Manual De Instrucciones página 18

SFA 6600
FIRST USE
 Before using the humidifying fan for the first time:
 Carefully unpack the misting fan and remove all packaging materials.
 Please refer to Image I. Check for missing parts, the humidifier fan can be
assembled only when the parts are complete.
 Use a soft cloth to remove surface dust that may appear during packaging and
transportation.
 Place the fan on a flat, stable surface.
INSTRUCCIONES DE MONTAJE
1. Image II: Unscrew the screw of the short tube and then pass the cable through the
long tube. Next place the long tube on top of the short tube. Align the tube hole on
the base and fix it with the screw.
2. Image III: First install the counterweight on the base and fix it with the M5x25
screws. Insert the 5 wheels into the holes under the base.
3. Image IV: Place the water tank on the base of the humidifier, making sure it is
properly seated in the gap.
 Place the lid on top of the water tank.
 Insert the lower flexible hose of the fan body into the water tank cover (make sure
the hose is not kinked).
4. Picture V: Loosen the fixing screw of the fan body, and then connect the terminal of
the fan body and the terminal wire into the tube. Tighten the screw.
5. Image VI: Install the rear grille, plastic nut, blade and blade fixing nut onto the motor
shaft and secure them in place.
6. Image VII, VIII and IX: Install the front grille and retaining ring, and secure them
using the ring screw. Insert the upper flexible hose into the steam diffuser located at
the front of the fan grill (make sure the hose is not kinked).
FILLING THE WATER TANK
1. Image X or XI: Remove the water tank cover.
2. Fill the tank with cold, clean water, make sure not to overfill it.
3. Image IV: Place the lid on the reservoir and replace it on the base of the humidifier.
18