Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the wall cupboard
This extractor hood is designed to be
installed in a wall cupboard with the follo-
wing dimensions:
width: 600 mm
depth: 293 to 350 mm
height: min. 435 mm.
If the cupboard is deeper than 293 mm,
the extractor hood can be moved back,
e.g. to put a spice rack in front of the
extractor hood.
To do this, place the template
back.
Ensure that the cupboard is stable both
during and after installation, even if fitted at
the end of a row of kitchen units.
Do not install the extractor hood at the
end of the kitchen line.
Align the cupboards exactly. If required,
place the side cupboards flush underneath.
The side panels must not project over
the base of the adjacent unit by more than
0.5 mm.
Weight in kg:
Exhaust air
16,0
We reserve the right to construction changes within the
context of technical development.
30
O
further
II
Circulating air
16,5
1. Mark two attachment points on both the
right and left inside faces of the cup-
board and make holes with a bradawl.
When you drill:
2 mm diameter – max. 10 mm in depth.
Use the enclosed template
the attachment points.
2. Screw on both attachment plates.
3. Attach the door to the cupboard and
align.
Observe the minimum distance
between hotplates and extractor hood!
Fig. 1.
O
to mark
II
Publicidad
