Magerit Metro Manual De Instrucciones página 21

Synchronization with external clock
METRO can use both its internal clock and an external one. To use a clock signal from any other module,
connect a jack between the module and the input of METRO. If you're in the sequencer menu (step or
Euclidean), you'll see "BPM" change to "EXT". Below it, you'll find the type of detection: Beat or 1/16.
The maximum value (high) of the clock signal must be above 3.5V.
It indicates that an external clock signal is connected.
Module calibration
To improve the accuracy of the CV inputs readings of the module, press and hold the
the module. Right after resetting it, release the button. The TEST menu will appear. By pressing the enco-
der, you can invert its direction. Press the
jacks and the USB-C cable (it's recommended not to leave it connected while using the module) and press
any button. Done!
The calibration and encoder direction will be saved automatically.
EXT RATE
1/16 ÷4
CH. S P R
3 5 3 0
button again to access the calibration screen. Disconnect all
Magerit
In Beat mode, each time
METRO receives a clock pulse,
the sequencer will advance
one step.
In 1/16 mode, every 4 clock
signals read, the sequences
will advance one step.
button and reset
21