Zendure SuperCharged Hyper 2000 Manual Del Usuario página 14

Idiomas disponibles

3. Connect to the Power Grid

Using the provided AC power cable, connect the power cable to Hyper 2000 first, then plug it into a household power socket.

1. Please confirm that the AC socket is switched on, and the power grid is being powered.

2. To improve the power generation efficiency and enhance safety, it is recommended that you connect it to a circuit with

lower load power or no other loads.

4.Connect to a Solar Panel

1. Install solar panels in their desired location before connecting them to your Hyper 2000.

2. There are two MPPTs in Hyper 2000. PV inputs 1 and 2 share MPPT1, and inputs 3 and 4 share MPPT2.

3. Please note that the Voc (open circuit voltage) on each PV input must be lower than 55V.

4. The total combined input current for PV1 and PV2 should not exceed 20A, and the same for PV3 and PV

5.Recommended maximum power range for connecting the solar panels to each PV input is between 350W~550W.

Connect Each Solar Panel Directly

(1）PV inputs 1 and 2 share MPPT1, and inputs 3 and 4 share MPPT2.

(2) The positive and negative terminals of the same solar panel must be connected to the same MPPT, for example, only to PV1

and PV2, or to PV3 and PV4.

400W