Zendure SuperCharged Hyper 2000 Manual Del Usuario página 18

8.2 Troubleshooting
If the LED light strip turns yellow or red, there is a warning or error. Please follow the instructions in the app or the table below to
address the problem. lf it is not resolved, please contact our customer service.
Do not attempt to repair the Hyper 2000 hybrid inverter.
!
LED Indicator LED Description Detailed Explaination Suggestion
Solid yellow on the Battery level is below
left side XX% and not charging
Blinking yellow on
Battery not connected
the left side
Blinking yellow on Home grid not
the right side connected
Blinking yellow on Both battery and home
both sides grid not connected
Blinking red on the Abnormal status of
left side Battery
Blinking red on the Abnormal status of
right side Hyper 2000
Blinking red on Abnormal status of
both sides Hyper 2000 and Battery
1. Make sure the both sides of the
solar panel cable and AC power
cable are correctly wired. Unplug
all the cables and reconnect after
30s
2. Make sure the home grid and solar
panels are working normally.
3. If the issue persists, contact
customer service.
1. Lift the Hyper 2000 placed on the
battery, and then put it back down
2. If the issue persists, contact
customer service.
1. Try pulling out the AC cable and
inserting re-inserting it. Make sure
that the plug is inserted well.
2. If the issue persists, the power
grid is probably faulty; wait for the
power grid to recover.
3. If the issue persists for more than 1
hour, contact customer service.
1. Lift the Hyper 2000 placed on the
battery, and then put it back down
2. Try pulling out the AC cable and re-
inserting it. Make sure that the plug
is inserted well.
3. If the issue persists, contact
customer service.
1. Check the cause and resolution
suggestions for abnormal faults in
the Zendure App.
2. If the issue persists, contact
customer service.
EN
15