Publicidad
Idiomas disponibles
Idiomas disponibles
level 1 when booting.
4) The button "
" is to select the thermal moxibustion mode. And
the " 0 " means stopping thermal moxibustion, while the " 1 " means
low temperature and the " 3 " high temperature. It defaults to " 2 "
when booting.
5) After the massage is completed, please shift the toggle switch
to "OFF" position to power off the massager; then, stick the
electrode slices on the storage board for storage in a dry,
well-ventilated place for next use.
6) When the battery runs low, please charge it with the power
adapter provided for the massager; otherwise, the massager will
be off automatically after the indicator flickers for alarm.
7) When the remote control backlight flickers or becomes
insensitive, it is recommended to replace the button battery (3V,
CR2032 type, and others are not allowed); the normal service life of
the battery is more than three months.
Attention: When you use the remote control to operate the
massager, the IR receiving window on the massager and the IR
sending window on the remote control cannot be
shielded; furthermore, please aim the remote control at the
receiving window as much as possible to get the best sensitivity.
8) Use of silicon electrode slices
1.Insert one end of the 2-core connector wire into the electrode
port and connect the other end to the electrode slices; then, use
the massager as specified above.
If they are used together with the conductive plates, there will be a
little difference in intensity due to the parts they are applied are
different, which is normal.
2. T he electrode slices should be clean on their surfaces without
any dust, oily or sticky substance; otherwise, the viscosity will be
reduced. If their surfaces become dirty, please flush with clean
water and then dry them in the air for repeated use.
3. T he electrode slices could be used for about 80 times (20
minutes for each time). If their viscosity still cannot be recovered
after several times of cleaning, please consider to purchase new
ones from your local dealer or the manufacturer.
4.Only the electrode slices provided for the massager, each with a
size of 55mm wide, 80mm high and 2.5mm thick, could be used;
and others are not allowed.
5.Please dispose the waste electrode slices according to your local
environmental regulations rather than discarding them at will.
It is recommended to use the massager for one to two times a day,
10 to 20 minutes every time of massage in electric impulse mode
and 15 to 30 minutes every time of thermal moxibustion.
9) Charge the battery
When the buzzer beeps for continuous three times during
massage, it indicates the built-in lithium battery runs low and needs
charging with the USB charging cable. Then, shift the toggle switch
to "Charge" position, with the power indicator turning green and
Publicidad
