Publicidad
Idiomas disponibles
Idiomas disponibles
Programming a user code
There are two ways to program a user code.
1
2
1
2
Keep your new user code secure
For your records, please copy it here:
Programming a user PIN
1
Press the Program button.
Press it a second time.
2
3
Enter your 5-digit User Code. The green LED remains ON.
Enter the 5-digit User PIN of your choice (any combination except 00000.) After 5 digits
4
are entered, the green LED turns OFF.
(To enter a new User PIN, repeat these steps. To erase the User PIN, press Program twice,
enter your User Code and then enter 00000.)
If your electronic lock fails or you do not have any codes available, you may use the
override key that comes with the unit.
Key override
1
All manuals and user guides at all-guides.com
Lock instructions
Press the Program button. (Prog).
Enter the Factory Code. The green LED remains ON while you
enter the 5-digit user code of your choice. After 5 digits are
entered the green LED turns OFF.
(To enter a new User Code, repeat these steps.)
–OR–
Press the red button on inside of door (hinge side). The lock will
"beep" and the green LED will come on.
Enter a 5-digit user code.
(To enter a new User Code, repeat these steps.)
Using two hands, hold the keypad, thumbs down, on its left and
right sides. Push up the keypad with your thumbs, disconnect
and remove the battery holder.
6
Publicidad
