Publicidad
Idiomas disponibles
Idiomas disponibles
▪
To fit: raise the rear cover and hitch the grass catch bag on rear of mower.
▪
To remove: grasp and lift the rear cover, remove the grass catch bag.
12.2.4 Edge cutting
Lawn mower is designed so that the diameter of the deck lies outside the line of wheels. In this
way you can cut the edges very easily.
13
MAINTENANCE
IMPORTANT - Regular, careful maintenance is essential for keeping the
safety level and original performance of the machine unchanged in time.
Stop the engine and disconnect and earth the spark plug before any repairing
or maintenance operations.
Warning! Risk of injury due to dangerous moving parts!
Complicated operations – not listed here below – must be carried out by a
specialized technical assistance centre.
The replacement of the cutting device should be done by a qualified
specialist! Rework or sharpening blades is not recommended unless it is
done by a repair service or a similarly qualified specialist!
▪
Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
Regular maintenance is essential for safety and performance.
▪
Never store the equipment with fuel in the tank inside a building where fumes can reach
an open flame, a spark or a source of extreme heat.
▪
Allow the engine to cool before storing in any enclosure.
▪
To reduce the fire hazard, keep the engine; exhaust silencer, battery compartment and
petrol storage area free of grass, leaves, or excessive grease. Do not leave containers
with grass cuttings in doors.
▪
Replace worn or damaged parts for safety. For reasons of safety, do not use the
equipment with worn or damaged parts. Parts are to be replaced and not repaired. Parts
that are not of the same quality can damage the equipment and be dangerous for your
safety.
▪
If the fuel tank has to be drained, this should be done outdoors and when the engine is
cool.
▪
Check the self-closing guard and grass-catcher frequently for wear and deterioration.
▪
Whenever the machine is to be handled, transported or tilted you must:
Wear strong working gloves; grasp the machine at the points that offer a safe grip, taking
account of the weight and its distribution.
13.1
Changing/draining the oil
▪
The oil can be removed with an oil/fuel remover, for example, POWACG8015.
▪
Remove the oil cap.
▪
Use the oil/fuel remover to remove the oil.
▪
Add new oil and check the oil level.
▪
After changing the oil, replace the oil cap.
▪
Make sure that the ring is in place and remove all spilt oil.
▪
Start the engine and let it run for a short while.
Copyright © 2024 VARO
POWXG60300
P a g e
| 15
EN
www.varo.com
Publicidad
