Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 CLEANING THE FLOOR NOZZLE
Thanks to ANTI-TWIST feature, your Hoover vacuum features an integrated comb which radically
reduces hair wrapping around the brushbar. However, if your cleaner is not picking up efficiently your
brushbar may need to be cleaned.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
1. Unlock the nozzle window sliding the nozzle window release latch and remove.
2. Using the brushbar release latch, remove the brushbar from the nozzle.
3. Remove any excess debris from the brushbar. Check for and remove any large debris from inside the
nozzle. Carefully check for and remove any tangled debris from the comb.
4. Refit the brushbar to the nozzle ensuring the latch is fully in place. The brush bar can only fit in one
direction. Press the end slightly to make sure the brush bar is in place.
5. Close the window by pressing gently on the middle area until you hear it "click" into place. Check
the window is completely locked by pressing on both sides.
IMPORTANT: Ensure the window is fully closed. If the nozzle window is not correctly reassembled,
the nozzle LED lights will flash and the brushbar status light will turn red.
4
5.2 CLEANING 2in1 FILTER
It is recommended to wash your filters after every 5 bin empties.
1. Ensure your product is switched off. Press the handheld release button and remove the handheld unit from the
main body.
2. Pull out the 2in1 filter assembly from the main body.
3. Remove the external sponge and wash separately the two parts in lukewarm water and leave to dry for 24
hours.
4. Reassemble once completely dry and refit to the product.
5. Refit the handheld unit into the main body, inserting front first then the back.
NOTE: Do not use hot water or detergents when cleaning the filter. In the unlikely event of the filter becoming
damaged, fit a genuine Hoover replacement.
1
1
5
2
2
3
8
3
4
5
GB
Publicidad
