General Description; Installation; Transport And Handling; Dimensions - ECOFOREST ecoSMART e-source Manual Deusuario, Instalador Y Servicio Técnico

2. General description

The ecoSMART source manager is an electronic controller designed to manage several brine energy sources, such as geothermal
circuits or antifreeze/air aerothermal units. It can work with a single ecoGEO HP heat pump or with a cascade of several ecoGEO HP
heat pumps controlled by an ecoSMART supervisor module. In order to do so, pLAN bus communication must be established with
the heat pump or cascade of heat pumps.
The e-source manager can manage up to four independent brine sources. Each source can be configured as an aerothermal or
geothermal brine source. It is also able to control defrosting of each of the aerothermal sources independently and in sequence,
while the heat pump(s) continue(s) to work with the other sources. It can also control a general circulator pump for all brine
sources.

3. Installation

3.1. Transport and handling

Transport the e-source manager so that it is protected from bad weather.

3.2. Dimensions

The general dimensions of the unit are set out below.
130 130
260 260

3.3. Unpacking

To unpack the e-source manager, carefully remove the box and check that the unit has not been damaged during transportation.
ecoSMART e-source
130
400 400
Figure 3.1. General dimensions (in mm).
260
40
user, installer and technical service manual
400