Brine Collector Inlet And Outlet Temperature Probes; Main Brine Pump Control - ECOFOREST ecoSMART e-source Manual Deusuario, Instalador Y Servicio Técnico

Type of power supply
1/N/PE 230 V / 50-60 Hz
Figure 4.10. Connection scheme of the e-source manager power supply.

The power supply of elements controlled by DO digital outputs must be independent.
NOTE

4.3. Brine collector inlet and outlet temperature probes

Install a temperature probe before the inlet of the brine collector and another after the outlet.
Description
Brine collector inlet temperature
Brine collector outlet temperature
Table 4.2. Connection terminals for the brine collector inlet and outlet temperature probes

4.4. Main brine pump control

In installations in which hydraulic separation is necessary, it is permitted to control an additional brine circulator pump.
Description
Main brine pump control
Type of protection/ Cut-off current
Magnetic, thermal and differential / 1A
Table 4.1. Characteristics of the e-source manager power supply.
Control Supply
230 Vac
Signal
Analogue input
Analogue input
Signal
Digital output
Analogue output
Table 4.3. Connection terminals for brine circuit components.
ecoSMART e-source
user, installer and technical service manual
Recommended cable section
Control Power
Supply 230V
DO1 DO2 DO3 DO4
L1 L2/N PE NC NC NC NC
COM COM COM COM
NO NO NO NO
pLAN BMS2 FBus AI1 AI2 AI3 AI4 AI5 AI6 AI7 AI8
24 Vac
Type
NTC 10K 25 °C Probe
NTC 10K 25 °C Probe
Type
Activation / 8A maximum
Regulation 0-10Vdc
49
2
1.5 mm
DO5 DO6 DO7 DO8 DO9 DO10 DO11 DO12 DO13
NC NC NC NC NC NC NC NC NC
COM COM COM COM COM COM COM COM COM
NO NO NO NO NO NO NO NO NO
AI9 AI10 AI11 AI12 AO1 AO2 AO3 AO4 AO5 DI1 DI2 DI3 DI4 DI5 DI6 DI7 DI8
Connector
AI1
AI2
Connector
DO1
AO1