Alarm Set - Sony YS-SX509P Manual De Instrucciones

Menu Setting Mode
Alarm and Sensor Setting
– Menu 4

ALARM SET

When an alarm trigger is received from sensors such as
a door bell, movement sensor, etc. you can set the
display mode and the recording mode for the pictures
from the concerned camera. Using the (SENSOR SET)
settings (see page 42 (GB)), the triggers received from
the video sensors can be set to operate as alarm
triggers.
Changing the Settings
1
Press the MENU button 4 times to display the
(ALARM SET) menu.
2
Using the + (or –) button, select the desired setting,
then press the v button.
• Repeat step 2, until all the settings are as desired.
3
Press the v button to go to the (SENSOR SET)
menu, or
Press the MENU button to go to the next menu
screen, or
Press the EXIT button to exit the menu display.
40
(GB)
(ALARM SET) menu
DURATION (Default setting: 10 S)
The available durations are (seconds):
1, 2, 3, 4, 5, 10, 20 (in 10 seconds increments)...
180, CC, NC, INDIV., OFF
CC: The alarm will go on as long as the alarm signal
is received (minimum 1 second).
NC: The alarm will continue until reset.
INDIV.: The alarm duration will be as set for each of
the cameras.
OFF: No alarm duration setting.
Note
If the "INDIV." setting is used, in the (CAMERA
SET) menu, enter the desired alarm duration for
each camera (see page 47 (GB)).
RETRIGGER (Default setting: OFF)
To set if an alarm is received while the unit is
already in alarm mode.
ON: During alarm mode, other alarm triggers will be
received and the alarm duration will be extended.
OFF: The unit will not receive another alarm, while
one is already being received.
BUZZER (Default setting: ON)
ON: A buzzer will be heard when an alarm trigger is
received.
OFF: The buzzer will not be heard.
DATA (Default setting: ON)
ON: The alarm data is recorded.
OFF: The alarm data is not recorded.