Publicidad
Idiomas disponibles
Idiomas disponibles
AttachingThe Steering Wheel
If the steering
wheel for your tractor
did not come attached,
the
hardware
for attaching
it has been packed within
the steering
wheel, beneath
the steering
wheel cap. Carefully
pry off the
steering
wheel cap and remove the hardware.
1.
With the wheels of the tractor
pointing
straight forward,
place the steering wheel over the steering shaft.
2.
Place the washer (with the cupped
side down) over the
steering wheel and secure with the hex bolt. See Figure 3-3.
Attaching The Seat
If the seat for your tractor was not attached
at the factory,
refer
to the following
steps.
NOTE: For shipping
reasons, seats are either fastened
to the
tractor seat's pivot bracket with a plastic tie, or mounted
backward
to the pivot bracket. In either case, free the seat from
its shipping
position
and remove the adjustment
knob from the
bottom
of seat before proceeding
with the instructions
below.
1.
As already instructed,
remove the seat adjustment
knob
installed
by the factory
in the bottom
of the seat. See "a" in
Figure 3-5.
2.
Align the seat over the seat pivot bracket as shown
in
Figure 3-5 and fit the seat onto the pivot bracket inserting
the two tabs on the seat bottom
into the slots on the pivot
bracket.
3.
Slide the seat rearward
in the seat pivot bracket (c),
lining
up the center rear slot in the pivot bracket with the
remaining
hole in the seat's base. See Figure 3-6.
Note: Be certain the two seat tabs engauge
the pivot
bracket as shown in the bottom
inset of Figure 3-6.
4.
Select desired position
for the seat, and secure with the
adjustment
knob removed
earlier (d in F gure 3-6).
Figure 3-3
3.
Place the steering
wheel cap over the center of the steering
wheel and push downward
until it "clicks" into place.
Attaching The DashCollarCIfequipped)
If the tractor's
dash collar did not come attached
from the
factory, the screws for attaching
it can be found
in either side of
the dash console.
Remove
the two screws
from the console
and
secure the dash collar as illustrated
in Figure 3-4.
®
Figure 3-5
\
\
Figure 3-4
J
SECTION
3--
ASSEMBLY &
SET-UP
Publicidad
