Descargar Imprimir esta página

Gorenje IR540W Manual Del Usuario página 8

Panel calefactor por infrarrojos

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
• To prevent overloading a circuit, do not plug the heater into a circuit that already has
other appliances working. Do not place the heater under the wall socket.
• It is normal for the plug to feel warm to the touch; however, a loose fit between the
socket (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn plug sockets.
• The output of this heater may vary and its temperature may become intense enough
to burn exposed skin. To avoid burns, the use of this heater is not recommended for
persons with reduced sensitivity to heat or delayed reactions.
• Do not cover the heater under any circumstances.
UNPACKING AND ASSEMBLY INSTRUCTIONS
PACKING LIST
1. Heater: 1 piece
2. 4x screws (ST 4*35mm)
3. 4x plastic fittings
4. 1x instruction manual
5. 1x wall mounting template
SELF-STANDING ASSEMBLY INSTRUCTIONS
1. Unscrew the two bottom corner screws on each side of the heater's back frame.
2. Align the self-standing bracket hole to the frame hole such that the outer corners of the bracket and heater frame
will be aligned.
3. Screw the previously removed screws back in. Make sure to screw them into the screw insert on the frame.
4. Start using your heater.
WALL MOUNTING INSTRUCTIONS
1. Measure the distance between the centre of each heater bracket both horizontally and vertically to ensure you
are drilling the holes in the correct place. Mark the positions of the 4 holes on the wall. You can also use the
enclosed template or the below table.
2. Drill the holes with an appropriate drill bit for the material you are mounting the heater on.
3. Insert the plastic fittings into the holes.
4. Screw the 4 screws into the plastic fittings. Leave the screw approx. 4 to 5 mm out of the wall. Minor adjustments
to the screws will be needed when putting the heater in place.
5. Attach the panel heater onto the screws and move the heater to the left so that
ing slots.
MODEL
A (cm)
IR540W
29,2
IR800W
42,4
IR1200W
64,4
- 8 -
B (cm)
24,4
39,6
36,6
the screws drop into the secur-

Publicidad

loading

Este manual también es adecuado para:

Ir800wIr1200w