Gorenje IR540W Manual Del Usuario página 9

OPERATING INSTRUCTIONS
1. When connected to a power supply, press the red
mechanical safety switch to the ON position. Switch
is located on the side of the operating panel.
2. The ON/OFF button will activate the heater to start
working with the ambient temperature pre-set to
37°C. If your room temperature is lower than 37°C,
the heater will start working immediately.
3. Set the desired room temperature using the "+" and
"-'' buttons.
4. TIMER CLOCK button will allow you to set a
countdown time for the heater. Adjust the desired
countdown time using the "+ '' and "-'' buttons.
INSTRUCTIONS FOR CONNECTING TO THE APP
1. On Google Play or the Apple Store, download the
following application:
a. Android https://play.google.com/store/apps/de-
tails?id=com.con.sec
b. Apple https://apps.apple.com/us/app/connect-
life-robot/id1613312684
QR – Apple
2. Open the application and perform the registration
process using a valid email or other suggested verifi-
cation method.
3. Turn on the heater and check that the Wi-Fi signal
is blinking rapidly (3 blinks per second). If not, press
the Wi-Fi button for 3 seconds to change the state of
blinking.
4. Turn on Wi-Fi and Bluetooth on your phone.
5. Tap Add device on your application home screen.
6. If the heater is not recognised automatically, find the
Small Home Appliances tab on the left side and tap
Heater (Wi-Fi) option.
7. Follow the steps requested by the application to add
the heater manually.
Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for envi-
ronmentally-safe recycling.
QR – Android
TROUBLESHOOTING
If your heater fails to operate, please follow these
instructions:
• Ensure that your circuit breaker or fuse is working
properly.
• Be sure the heater is plugged in and that the electrical
outlet is working properly.
• If the ON/OFF switch is not illuminated in the ON po-
sition, send it to the service centre directly for repair.
NOTE: IF YOU EXPERIENCE PROBLEMS WITH
YOUR HEATER, PLEASE SEE THE WARRANTY
INFORMATION FOR INSTRUCTIONS. PLEASE
DO NOT ATTEMPT TO OPEN OR REPAIR THE
HEATER YOURSELF AS TO DO SO MAY VOID THE
WARRANTY AND CAUSE DAMAGE OR PERSONAL
INJURY. IF THE PROBLEM PERSISTS, PLEASE
CONTACT THE DISTRIBUTOR.
CLEANING AND STORAGE
Before cleaning your heater, switch off the heater and
allow it to cool. Disconnect the electricity supply to the
appliance. The outside can be cleaned by wiping it
over with a soft damp cloth and then dried. Do not use
abrasive cleaning powders or furniture polish as this can
damage the surface finish.
For short term storage, just plug out the heater and
leave it; for long term storage, you can dismantle it from
the wall.
SPECIFICATIONS
Voltage:
220-240V, 50/60Hz
Power:
540 Watts for PH-ET540E1
800 Watts for PH-ET800E1
1200Watts for PH-ET1200E1
Tolerances on all specifications:
Approximately +5%, -10%.
LIMITED WARRANTY AND SERVICE
2 year manufacturer's warranty. Please contact your
dealer with your purchase receipt for warranty details.
- 9 -