Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3
Place the Fixed Shelf (C) into the position shown on the Left Side Panel (A) on the drawing ensuring that the
Cam Screws (H) engage with the Cam Locks (I). Make sure that the finish edge of the Fixed Shelf is facing the
front of the bookcase. Using a Phillips Screwdriver rotate the Cam Locks (I) 1/2 turn clockwise until snug.
Insert the Kickplate (E) into the position shown. Tap into secure position with a Rubber Mallet.
Insert the Trim Panel (G) into the position shown. Tap into secure position with a Rubber Mallet.
Making sure that the finish edge is facing consistently, place the Right Side Panel (A) onto the Fixed Shelf (C),
Kickplate (E), and Trim Panel (G) making sure that the Cam Screws (H) and Wooden Dowels (K) engage with
the Cam Locks (I) and holes shown. It may be necessary to tap into secure position with Rubber Mallet. Once
properly seated, use a Phillips Screwdriver and rotate the Cam Locks (I) 1/2 clockwise turn until snug. (DO
NOT OVER TIGHTEN)
A
Left/Right Side Panel
I
E
C
Kickplate
C
Bottom Shelf
Bottom Shelf
E
Kickplate
G
Trim Panel
G
A
A
Trim Panel
Left/Right Side Panel
Left/Right
Side Panel
LLR36420/60065 (42")_LLR36480/60066 (48")_030206
Page 4 of 15
Publicidad
