VOSS.farming XTREME DUO WIFI Instrucciones De Operación página 58

Fault/problem
Voltage loss/leakage
from the fence
Fence voltage
insufficient
Grounding voltage is
not displayed
Error E1
Error E2
58
Solution
∙
Remove vegetation from the fence (by mowing or pruning).
∙
Check whether the insulators are defective (recognisable by
"clicking" and, possibly, sparking of insulators). Replace defective
and weather-worn insulators.
∙
Check whether the conductor material is touching the ground (e.g.
as a result of breakage, insufficient mechanical tension). Repair
the fencing. Use only special connection pieces and tighten the
conductor material.
∙
Check whether the conductor material possesses any undesirable
properties (thin conductor, high resistance). Use high-quality
conductor material with a low resistance and large diameter. Ensure
that the conductor material has high-quality wiring.
∙
Make sure that the conductor material is not connected using tied
knots, and that the connection is adequate. Use suitable special
connection pieces for the conductor material.
Fence too long. Reduce the area or use a more powerful energiser.
No grounding post connected to the green connector to check the
grounding voltage and/or fence resistance is > 500 ohms (see Section
7.4.3).
Fault in measurement of output voltage The fence system is not
working properly. The output of the energiser is limited to 5 J and
the measurement of the grounding is not being carried out. Contact
our Service department.
Communication processor fault. Contact our Service department.
INSTRUCTION MANUAL VOSS.FARMING XTREME DUO WIFI
41585 - 04.2023 - V1