PRIXTON RUN FIT CARDIO RF250 Manual Del Usuario página 19

CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplug the treadmill before cleaning
or performing routine maintenance.
WARNING: Always check the wear and tear components like spring knob and running belt to
prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed from the
unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not to get excessive moisture on the display panel as this might damage
the unit and create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to prevent
damage to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit outdoors.
Ensure the master power switch is off and the power cord is un-plugged from wall outlet.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not start.
Potential Causes
1.Treadmill not plugged in.
2.Safety Tether Key is not correctly installed.
3.Circuit breaker in the house has been tripped.
4.Treadmill circuit breaker has been tripped.
Corrections
1.Plug the power cord into a wall outlet.
2.Reinstall the Safety Tether Key.
3.Reset the circuit breaker, or call an electrician to replace the circuit breaker.
4.Wait 5 minutes and then try to restart the treadmill.
Problem
Belt slips.
Potential Causes
Belt not tight enough.
Corrections
Adjust belt tension.
Problem
Belt hesitates when stepped on.
Potential Causes
1.Not enough lubrication applied onto the running deck.
2.Belt is too tight.
Corrections
1.Apply lubricant.
2.Adjust belt tension.
Problem
Belt is not centred.
Potential Causes
Running belt tension not even across the rear roller.
Corrections
Centre the belt.
19