Publicidad
Idiomas disponibles
Idiomas disponibles
•
Drive wheels:
Remove the protective film from the wheel, then press and hold the pin in
the center of the wheel, sliding it over the axle to the end, so that the 4
protruding bolts from the wheel engage the holes in the hub (see pictures
below).
IMPORTANT: on both ends of the axle there are 2 grooves – the first (a)
only blocks the wheel from sliding off the axle, but does not connect the
wheel with the drive, only on the second (b) the wheel is connected to the
motor. The first groove is an emergency in case the battery runs out and
you need to manually control the trolley with the drive disconnected, i.e.
with unlocked wheels.
Supporting and stabilizing wheel:
•
Slide the supporting-stabilizing wheel set onto the protruding pin on the
product frame until it clicks, ensuring the corresponding holes on both
EN
Publicidad
