UNIPRODO UNI GT 02 Manual De Instrucciones página 48

• NOTE: If no button is pressed for 30 seconds on the remote
control, it automatically enters standby mode. To exit the
standby mode, press the "STOP" button.
• Each press of the control button will momentarily illuminate the
LED at the top of the front casing of the remote, indicating the
signal being transmitted to the device.
• The trolley has 3 driving speeds in both directions, i.e., forward
or backward. The direction of travel forward or backward is
regulated on the remote control by the up or down directional
button (arrow), i.e., pressing the up arrow will cause the trolley
to move forward, and the down arrow will move it backward. In
addition, the speed of travel in a given direction is controlled by
the appropriate number of presses of the directional button, i.e.,
if you want it to move forward at the slowest speed, simply press
the up arrow once; a bit faster, press it twice, and fastest, three
times, and similarly for the reverse direction. The selected speed
will be indicated by the lighting of the corresponding value
control ("0-1-2-3") on the remote control.
• To stop the trolley, press the "STOP" button.
• Pressing (and optionally holding down) the right or left
directional button will cause the cart to turn in the
corresponding direction indicated by the arrow.
• The 10Y/20Y/30Y buttons initiate automatic forward movement
of the cart over a limited distance for a set duration.
10Y - approx. 10 s / 10 yd (~ 9.1 m)
20Y - approx. 20 s / 20 yd (~ 18.2 m)
30Y - approx. 30 s / 30 yd (~ 27.4 m)
• The rear casing of the remote features two fasteners for
convenient transport when not in use – a string loop at the top
and a self-locking clip at the bottom, which can be used to attach
it to a pocket, for example.
EN