Water Tech PRECISION V10 Manual Del Operador página 10

Frequently Asked Questions
Q: Can my cleaner be run out of water?
A: Yes, for a short period of time when you turn it on before submerging into your pool or spa.
Q: When I am cleaning my pool how do I know when the cleaner is out of battery power?
A: Most people can feel the cleaner is running through vibration in the vacuum pole or handle. To be sure, you can lift it out of the water to hear if it is running
or not.
Q: How often should I clean out my cleaner's filter bag?
A: You can clean your filter bag as often as you like with no ill effects. The filter bag can then be turned inside out and rinsed with a hose or in a sink. Do
not wash it in a washing machine or with detergent. For more detailed instructions, see "Cleaning the Filter Bag" instructions in this manual. For best
results, do this after each use, or whenever you notice the performance of your cleaner declining.
Q: How can I stop dirt from coming out of the nozzle when I take the cleaner out of the water?
A: There are two ways to remove the unit from the pool when done cleaning:
WHEN USING HANDLE: Lift from pool with the nose facing up to allow the water to escape from the back and sides.
WHEN USING A VACUUM POLE: Remove the unit from the pool with the bottom facing upwards and the handle facing down. This will allow the water to
escape and keep the dirt inside.
Q: Where can I buy replacement parts?
A: Look for original Water Tech replacement parts at your local retailer or call 1-(732)-967-9888 for more details.
Q: Will my pool chemicals hurt the cleaner?
A: This cleaner is designed to withstand pool chemicals during its usage period. However, it should be rinsed off with fresh water after it is removed from the
pool. This will increase the life of the filter bag/seal ring.
Q: Can I leave the cleaner in the pool when not in use?
A: No. The cleaner should be removed from the pool and stored in a clean, dry place when not in use.
This will increase the life of your cleaner and its accessories.
Q: What do I do if my cleaner does not vacuum?
A: Make sure your cleaner is completely submerged in the water and the air is out of the clear funnel. The cleaner is only designed to vacuum water and will not
vacuum air. If that does not resolve your situation, please check the following:
• Make sure the filter bag is clear of debris that may be obstructing the flow.
• Charge your cleaner for at least 6 hours.
If none of the above help resolve the situation, please call our Customer Service Division at (732)-967-9888.
10