Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
a
b
2.
Close the door as much as you can. Take a firm
hold of the door with both hands – do not hold it
by the handle.
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating. Put the door to one side,
resting it on a soft surface.
~15°
b
a
TROUBLESHOOTING
PROBLEM
The oven is not working.
The display shows the letter "F" followed
by a number or letter.
The oven does not heat up.
The function does not start.
The light switches off.
The door will not open.
Drain pump activation some minutes
after end/stop of steam cycle
Policies, standard documentation and additional product information can be found by:
•
Using the QR code in your appliance
•
Visiting our website
docs.whirlpool.eu
contact our After-sales Service
•
Alternatively,
sales Service, please state the codes provided on your product's identi cation plate.
POSSIBLE CAUSE
Power cut.
Disconnection from the mains.
Oven failure.
"DEMO" mode is running.
"ECO" mode is "On".
Cleaning cycle in progress.
Expected automatic water drain
(See phone number in the warranty booklet). When contacting our After-
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and then open it fully. Lower the
catches into their original position: Make sure that
you lower them down completely.
a
b
Apply gentle pressure to check that the catches
are in the correct position.
"CLICK"
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not,
repeat the steps above: The door could become
damaged if it does not work properly.
SOLUTION
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Contact you nearest Client After-sales Service Centre and
state the number following the letter "F".
Acceess "DEMO" from "SETTINGS" and select "Off".
Acceess "ECO" from "SETTINGS" and select "Off".
Wait for the function to finish and for the oven to cool
down.
No action needed.
400011669609 REV. A
Publicidad
