Ombréa VS 15-728127 Instrucciones De Montaje página 36

Insert the cylinder PO into the gearbox NO and through the beam, then push the part until the
connection with the pin from the main louver.
Check if the louver rotates correctly from left to right and vice-versa using the hand crank HO.
PO
SO
Place the louver in a vertical position, in the right direction as shown to place and insert the
12
remaining louvers one after one. Then, insert the half-moon plastic cap SO as shown in the
36
drawing. The half-moon opening should stay at the bottom of the cap.