AENO EG5 Manual De Instrucciones página 11

cooking time and temperature. At the end of the countdown, an acoustic
signal sounds 5 times. The display will show: «DONE».
If you do not intend to use the appliance again, switch it off with the
«Start/Cancel» button and unplug it from the power socket.
Color indication of the grill modes
 blue – device is running in «Preheat» mode;
 green – the appliance is operating in the «Preheat» mode;
 yellow – device is working in «Food preparation» mode;
 red – operation in «Food preparation» mode has been completed.
Care and cleaning
Wait for the appliance to cool down, then carefully remove the grease drip
tray (8) and remove its contents. Remove the removable plates. Wash the drip
tray and the removable plates with a neutral detergent and dry them
thoroughly before putting them back in. Repeat the procedure after each
cooking operation. The tray and removable plates can be washed in a
dishwasher. Do not use metal brushes or abrasive cleaning products. Clean the
body of the appliance with a damp cloth and a little detergent. Then wipe the
surface with a dry cloth.
Troubleshooting possible problems
1. The grill does not switch on. Possible causes: The power socket is defective,
or the plug is not fully inserted into the socket. Remedy: Make sure there is
power in the socket (e.g., by plugging in another functioning appliance) and
that the grill plug is fully inserted into the socket.
2. The grill is switched on, but the removable plates are not heated. Possible
reason: The appliance has not been set in the operating mode. Remedy:
Make sure that the operating time and temperature are set on the display
and that the «Start/Cancel» button is pressed.
Device error codes displayed on the display
 E1 – contact breakage of the upper thermostat;
aeno.com/documents 11