Publicidad
Idiomas disponibles
Idiomas disponibles
D
1509)50-4
How to load your dishes
Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer.
Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough
incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well
First of all.
Before placing the dishes in
the racks, remove the
largest scraps of food left
over on your plates, you will
thus avoid blocking the
filter, which would reduce
the efficacy of the wash.
If the saucepans and frying
pans are very dirty, allow
them to soak before being
washed. To make it easier
to load your dishes, pull the
racks out.
What goes into the
lower rack?
We recommend you place
the most difficult dishes to
wash into the lower rack:
saucepans, lids, soup dishes
and plates (a load example
is shown in the photo).
• Serving dishes and large
lids: place them on the
sides of the rack.
• Saucepans, salad bowls:
must always be placed
upside down
• Very deep dishes: place
them
obliquely,
allowing water to run
down them and cleaning
them better
Place the cutlery with
the handles at the bottom;
if the basket is the one with
side inserts, then insert the
tea spoons one by one into
the slots (see figure A).
Knives and other utensils
with sharp point must be
loaded in the basket with
their point down or placed
in a horizontal position in
the upper basket equipped
with one or two tip up
compartments.
Position all cutlery items so
that they don't touch.
It is best if you place longer
utensils horizontally at the
front of the upper rack.
After loading the dishes,
remember to check that the
blades on the sprayer arms
14 ARISTON DISHWASHER - Instructions for installation and use
can turn freely without
hitting against any dishes.
What goes into the
upper rack?
Place
delicate
lightweight dishes in the
upper rack: glasses, tea
cups and coffee cups,
saucers - but plates too -
shallow
salad
slightly dirty frying pans
and shallow pans.
Position lightweight dishes
in such as way as to avoid
their being moved by the
spray of water.
The appliance can also be
equipped with 2 or 4 tip-
up compartments onto
which you can place mugs
and cups, as well as long
sharp knives and serving
cutlery.
How to adjust the top
rack.
The upper rack can be set
in high or low position to
enable you to organise your
dishes effortlessly.
thus
1
3
F
Open the rail stop flaps and
pull the rack out completely.
Now place it in high or low
position, then slide it along
the guide rails until the front
wheels also go in. Now close
the rail stop flaps. Follow the
sequence of actions
illustrated in figure "F".
and
bowls,
Loading examples for the upper rack
Loading examples for the lower rack
2
4
Fig. A
Publicidad
