Publicidad
Idiomas disponibles
Idiomas disponibles
Starting the dishwasher
Ready, steady, go!
You have loaded your dishes and you now have
to set the wash cycle. It takes just one minute
to learn how
First of all.
After performing all the
operations described in the
previous paragraphs, turn
the water tap on completely
and press ON-OFF button
"A", and the indicator light
"B" lights up. Now the
appliance is on and ready to
be programmed.
Selecting the wash
cycle.
To select the wash cycle,
turn knob "D" clockwise
until the reference notch on
the knob corresponds with
the number or symbol for
the cycle you wish to set
(have a look at the wash
cycle table on page 17).
The indicator light "E" re-
lative to the cycle start
phase will go on.
The dishwasher keeps
you informed.
Your dishwasher is fitted
with indicator lights (E)
which light up to indicate
the cycle phase under way.
Here are the symbols cor-
responding to each cycle
phase:
pre-wash, wash, rinses, dry-
ing.
At all times, your dish-
washer tells you which cy-
cle phase is under way.
You can modify
the wash cycle in
progress, if it
has only just
s t a r t e d .
Modifying a wash
cycle in progress.
But if you have chosen the
wrong cycle, not to worry!
You can modify the wash
cycle in progress, if it has
only just started. Turn the
knob anti-clockwise until it
reaches the Reset position
and, after a few seconds, the
indicator light "E" will turn
off. This is to inform you
that all the settings have
been cancelled. You are now
free to re-set the correct
wash cycle.
Finished?
The end of the wash cycle
is indicated by the flashing
of the drying phase indica-
tor light.
Warning:
Turn the knob anti-
clockwise to Reset in
order to reset all the
settings.
Turn
the
appliance off by pressing
button "A", unplug the
appliance
from
the
electricity socket to cut off
the power supply; the
power supply cable should
consequently be easily
accessible.
Turn off the water tap.
Wait a few minutes before
unloading the dishes: they
are very hot! If you wait a
little while, they dry better
thanks to the steam.
Empty the lower rack first.
Make sure the
wash cycle has
ended before
removing the
d i s h e s !
You've left out a dish?
Well, it happens to every-
one. Interrupt the wash cy-
cle by pressing the ON-OFF
button, insert the dish you
had forgotten and press the
ON-OFF button again. The
cycle will start up from
where you interrupted it.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and
then restarts when the
electricity comes back on or
when you close the door.
Everything is under control!
ARISTON DISHWASHER - Instructions for installation and use
D
1509)50-4
If opening the door
soon after the end
of the
p r o g r a m m e , o r
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
s t e a m .
15
Publicidad
