Publicidad
Idiomas disponibles
Idiomas disponibles
4.9. Cameras configuration
If the "Enable" box is checked means that a camera is detected on that channel. Otherwise it
will mean that no camera is active on that channel and configuration is not possible.
To change the settings of a camera click on the dropdown menu and select the desired
camera / channel. Change the settings according to your needs.
Step 1:
To config motion detection areas go to "Region" and click the "Setup" button.
Step 2:
On the new window click and drag the mouse to config motion detection areas.
It is possible to create and configurate up to 4 different areas with their own parameters.
Define the area sensitivity for each area according to your needs.
Once the motion detection areas are set click "OK" to save the settings.
Step 3:
Once the camera setting are complete click "Next".
Step 4:
The 1st time setup is complete and the NVR will log out. To access the NVR again please refer
to chapter "5. Managing your NVR".
12
Publicidad
