DeWalt DW955 Manual De Instrucciones página 2

F YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY DEWALT TOOL, CALL US TOLL FREE AT:
1-800-4-DEWALT (1-800-433-9258)
Gereeral Safety Rules - For All Battery
Operated Tools
WARNING! Read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
Keep your work area clean and well lit. Cluttered benches and
dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such
as in the presence of flammable liquids, gases, or dust. Power
tools create sparks which may ignite the dust or fumes.
Keep bystanders, children, and visitors away while operating
a power tool Distractions can cause you to lose control
ELECTRICAL SAFETY
Do not abuse the cord. Never use the cord to carry the tool.
Keep cord away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately. Damaged cords may create
a fire.
• A battery operated tool with integral batteries or a separate
battery pack must be recharged only with the specified
charger for the battery. A charger that may be suitable for one
type of battery may create a risk of fire when used with another
battery.
Use battery operated tool only with the specifically
designated battery pack. Use of any other batteries may create a
risk of fire.
PERSONAL SAFETY
Stay alert, watch what you are doing and use common sense
when operating a power tool Do not use tool while tired or under
the influence of drugs, alcohol, or medication. A moment of
inattention while operating power tools may result in serious
personal injury.
Dress properly. Do not wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing, and gloves away from moving
parts. Loose clothing, jewelry, or long hair can be caught in moving
parts. Air vents often cover moving parts and should also be avoided.
• Avoid accidental starting. Be sure switch is in the locked or off
position before inserting battery pack. Carrying tools with your
finger on the switch or inserting the battery pack into a tool with
the switch on invites accidents.
Remove adjusting keys or wrenches before turning the tool
on. A wrench or a key that is left attached to a rotating part of the
tool may result in personal injury.
Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of the tool
in unexpected situations.
Use safety equipment. Always wear eye protection. Dust mask,
non-skid safety shoes, hard hat, or hearing protection must be
used for appropriate conditions.
TOOL USE AND CARE
Use clamps or other practical way to secure and support the
workpiece to a stable platform. Holding the work by hand or
against your body is unstable and may lead to a loss of controL
Do not force tool. Use the correct tool for your appfication. The
correct tool will do the job better and safer at the rate for which it is
designed.
Do not use tool if switch does not turn it on or off. A tool that
cannot be controfled with the switch is dangerous and must be
repaired.
Disconnect battery pack from tool or place the switch in the