Publicidad
Idiomas disponibles
Idiomas disponibles
Power Supply
OPE/BATT—>
a
FUNCTION
ilrrn
II
—
hlllllll
I[llu
IMPORTANT
Make sure that FUNCTION is set to POWER Cl STANDBY
before connecting
the AC cord or inserting batteries.
Connect the AC cord as illustrated
below.
@) to the AC inlet of the unit
~
+
@to an, AC outlet
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Open
the lid of the battery compartment
on the rear and
insert eight R20 (size D) batteries, not supplied, as illustrated
below. Then close the lid.
Before using on batteries, disconnect the AC (cord from the
AC inlet. Battery power is cut off automatically
when the
cord is connected.
When the OPE/BATT
indicator becomes dim, the tape speed
slows down, volume decreases,
or sound is distorted during
operation,
replace the batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
Insert the batteries with the 0 and o marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
When
the
unit is
not to be used for a long period, remove
the batteries.
Never recharge the batteries, apply heat to them or take
them apart.
c Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly
to remove.
Connections
IMPORTANT
Make sure that the AC cord is disconnected
and batteries
are removed before connecting
speakers.
Do not connect other than the supplied speakers.
~
Position the speakers.
To couple with the speakers,
slide each speaker
down
into the guide
brackets
on the center
unit
until the height
is level with the unit.
To separate the unit from the speakers,
slide the
speakers
up and off, while pressing the speaker
release knob.
2
Connect the speakers.
Connect the right speaker cord to the R terminals,
and the left speaker to the L terminals.
Connect the s~eaker cord with the white broken
line to O and \he other cord to
0.
Insert two R6 (size AA) batteries.
R6 (AA)
When the reach of the remote control signal is less than 5
meters (16 feet), replace the batteries.
The remote control may not operate correctly when:
-
The unit is exposed to intense light, such as direct sunlight
-
Objects block the remote control signal to the unit
ENGLISH
3
Publicidad
