Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3
4
5
6
Set FUNCTION
to TAPE.
Insert a tape to be recorded
on into deck 1 with
the side to be recorded facing out.
Insert a tape to be played into deck 2 with the
side to be played facing out.
Press 11 PAUSE then press
REC on deck 1
to enter recording
pause mode.
-
PLAY is pressed simultaneously.
Press DUBBING
SPEED to select a dubbing
speed.
The HI-SPEED
DUBBING indicator lights up: Dubs
at high speed.
The HI-SPEED
DUBBING indicator disappears:
Dubs at normal speed.
Press >
PLAY on deck 2.
1I PAUSE on deck 1 is released and recording
starts.
To stop recording,
press W4
on deck 1.
To erase a recording,
set FUNCTION to TAPE and press
REC.
After recording,
set FUNCTION to POWER (1)STANDBY.
NOTE
When recording near a television,
noise maybe
recorded.
Move the unit away from the television.
To prevent
accidental
erasure,
break off the Iplastic tabs on
the cassette tape with a screwdriver
or other pointed tool
after recording.
To record
on the tape again, cover the tab openings with
adhesive tape, etc.
ROCK – Emphasizes
the high and low range of music.
POP – Emphasizes
voice and midrange of music.
JAZZ – Emphasizes
the low range of music.
Press one and the indicator of the selected setting lights
up.
To cancel, press the selected setting.
QSOUND system
This system provides a rich, three dimensional
sound area.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
At higher volumes, turning QSOUND on may cause
sound distortion.
In this case, turn the volume down.
PHONES jack – Headphones
with a stereo mini-plug
(not
supplied) can be connected to this jack.
Connect a microphone
with a mini plug to the MIC jack
and play a source to be mixed.
To record the microphone
mixing sound, insert a tape in
deck 1 and press
REC.
During dubbing at high speed, the microphone
mixing
sound is not recorded.
MIC VOL – Adjusts the microphone
volume.
If a howling
sound
is
produced,
turn
the volume
down.
To prevent howling, hold the microphone
away from the
speakers. The use of unidirectional
type microphones
is
also recommended.
Y
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol,
benzine or thinner.
To clean the heads and tape paths
After every 10 hours of use, clean the heads 0 and 0,
the pinchroilers
0 and capstans 0.
Use a cotton swab ~
slightly moistened with cleaning fluid or denatured
alcohol.
Deck 2
T
To clean the lens
Lens
Use a cotton swab slightly
moistened
with cleaning fluid.
Wipe gently from the center to
the edge.
ENGLISH
7
Publicidad
