Publicidad
Idiomas disponibles
Idiomas disponibles
n
a
000
o–9, +10
000
000
D
00
u
00
00
000
0
CANCEL
~
Set FUNCTION
to RADIO.
Z
Select aband
with BAND.
~
s
Select astation
with+,
-TUNINGi
During FM stereo reception, the FM STEREO
indicator lights up.
4
Turn VOLUME
to adjust
the volume.
After listening, set FUNCTION to POWER (!) STANDBY.
For better reception
FM
AM
Extend the rod antenna and
The antenna is inside the
orient it for the best reception.
unit. Positiom the unit for
the best reception.
TUNER MODE/OSC/REPEAT
- If an FM stereo broadcast contains noise, press the
button so that [m
is displayed.
Noise is reduced, although reception is mcmaural.
To restore stereo reception, press the button again.
- If a high-pitched
sound is heard during recording from
AM, press the button repeatedly
until noise is reduced.
You can check its position by "=" turning on
or
off in the
display.
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent
lights, move the unit.
For quick tuning (Auto Search)
Keep +, – TUNING pressed until the tuner starts searching
for a station. When a station is tuned to, the search stops.
If the broadcast signal is weak, it does not stop. To stop
the search manually, press + or –.
To change the AM tuning interval
The default
setting
of the AM tuning
intervall
is 10 kHz/step.
If you use this unit in an area where the frequency
allocation system is 9 kHz/step, press BAND while
pressing
to change the tuning interval.
When the AM tuning interval is changed, the preset
stations are cleared.
You can preset up to 15 stations in each band.
1
Select a station,
Z
Press MEMORY
until "M" is displayed to store
the station.
A station is assigned a preset number, beginning
from 1 in consecutive
order for each band.
Preset number
Freq;ency
3
Repeat steps 1 and 2.
The next station will not be stored
n
if a total of 15
preset stations have already been stored for a
band.
To listen to preset stations, select a band then press Hll
PRESET repeatedly.
To clear a preset station, display the preset number then
press MEMORY while pressing Fill
PRESET. The higher
numbers in the band are decreased
by one.
Buttons on the remote control and the main unit with identical
indications
have the same functions.
To select the preset number directly
Press the numbered
buttons and +1 O button.
Example:
To select number 15, press the +1 O and 5 buttons.
To select number 10, press the +1 O and O buttons.
ENGLISH
5
Publicidad
