Racing RAC437KIT Manual Del Usuario página 39

38
4.4- Adjusting
the
Throttle Cable
1.
Loosen
the
throttle cable nut at fan cover
as
shown in Fig.E6
2. Adjust the throttle cable adjuster nuts until
YOll
achieve a free play on the throttle trigger of about
6mm. See Fig.E7.
3. When 6mm free play is achieved, tighten the two !Omm throttle cable nuts.
When the throttle cable is correctly adjusted, and the throttle trigger is fully depressed (full throttle),
the throttle will contact the stop on the throttle body. See Fig.E8
4. Replace the air cleaner cover
4.3- Connecting Switch Wires
Connect the switch wires between the engine and
the
main unit.
Pair the wires of the same color. See Fig.E5
4.2- Connecting the throttle cable
I. Remove the air cleaner cover
2. Connect the end
of
the throttle cable to the joint on the top
of
the carburetor. See Fig.E3, Fig.E4
CAUTJON! Do
not force the lower tube into the
powerhead!
Excessive force can damage the
components.
Fig.E2
I. Throttle cable
2. Lower tube
3. Main
shaft
4. Tube clamp
5. CIamp screw