Publicidad
Idiomas disponibles
Idiomas disponibles
detect automatic switching off
or dry running of the pumps
in time. Regularly check the
function of the fl oat switch (see
chapter "Initial Operation").
Non-observance will invali-
date all guarantee and liability
claims.
• Please note that the pump is
not suitable for continuous op-
eration (e.g. for watercourses
in garden ponds). Check the
equipment regularly for correct
functioning.
• Note that the lubricants used in
the equipment may cause dam-
age or contamination if they
escape. Do not use the pump in
garden ponds with fi sh stocks or
valuable plants.
• Do not carry or fi x the equip-
ment by the cable or pressure
line.
• Protect the equipment from frost
and from running dry.
• Use only original accessories
and do not carry out conversion
work on the equipment.
• Please read the notes in the op-
erating instructions on the topic
of "Cleaning/Maintenance/
Storage". Any measures above
and beyond these, particularly
opening the equipment, are to
be carried out by an electrician.
In the case of repairs, always
contact our service centre.
Electrical safety:
Caution: to avoid accidents
and injuries from electric
shocks:
• After erection, the mains plug
must be freely accessible when
the equipment is in operation.
• Before operating your new
pump, have a specialist check:
- The earthing, the protec-
tive multiple earthing; the
residual current circuit break-
ing must be compliant with
the safety regulations of the
energy supply company and
function without fault,
- The protection of the electri-
cal plug connections from the
wet.
- If there is a risk of fl ooding,
fi x the plug connections in an
area that is safe from fl ood-
ing.
• Ensure that the mains voltage
matches the specifi cations on
the rating plate.
• The electrical installation shall
be according to national wiring
rules.
• Before each use, check the
equipment, cable and plug for
damage. Defective cables are
not to be repaired, but rather
replaced by new ones. Have
damage on your equipment re-
paired by an authorised special-
ist.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualifi ed
person in order to prevent haz-
ards.
• Do not pull the plug from the
socket by the cable. Protect the
cable from heat, oil and sharp
edges.
GB
IE
21
Publicidad
