Publicidad
Idiomas disponibles
Idiomas disponibles
8.2
TRANSPORT THE LITHIUM-ION
BATTERY
The US Department of Transportation and international
transportation authorities require that lithium-ion battery
be transported using special packaging and only be
transported by carriers certified to haul them. In the US,
you are allowed to transport a battery when it is installed
on the mower as battery powered equipment, with some
regulatory requirements. Contact the US Department of
Transportation or the appropriate government body in
your country for detailed regulations on transportation of
your battery or the mower with the battery equipped. For
detailed information on shipping a battery, contact your
authorized Greenworks servicing dealer.
8.3
MOVING THE MOWER MANUALLY
To push the mower manually:
1. Disengage the mower blades and depress and hold
the parking brake pedal, then fully depress the
brake pedal to set the parking brake.
2. Turn the key to the OFF position. Remove the key,
and wait for all moving parts to stop before leaving
the operating position.
3. Release the parking brake.
4. Move the mower to the desired location.
CAUTION
To avoid damage to the motor and drive system, do
not move the product faster than 5 mph (8 km/h).
9
CLEAN AND STORAGE
9.1
CLEAN THE PRODUCT
•
Remove any build-up of grass and leaves on or
around the motor cover (Do not use water).
•
Occasionally wipe the mower clean with a dry cloth.
•
If debris builds up on the underside of the mower
during use, stop the motor on level ground,
disengage the PTO switch, set the parking brake,
shut off the product, remove the start key and use
the compressed air to clean the area.
English
9.2
CLEAN THE MOWER DECK
•
Prepare the mower by parking it, setting the brake,
and lowering the mower deck.
•
Connect the hose (1) with quick-coupler (2) to the
wash port (3), turn on the water, start the mower
blades with increased speed, and flush under the
deck for about one minute.
•
Finish cleaning by disengaging the mower blades,
turning off the water, and disconnecting the hose.
•
Store the quick-coupler for future use.
•
Shut down the mower completely.
9.3
STORE THE PRODUCT
The following steps should be taken in order to prepare
the product for storage.
•
Clean the Mower: Before storing the product,
thoroughly clean it as outlined in the previous
section.
•
Blade Inspection and Maintenance: Inspect the
blades and replace them as detailed in the Service
the Mower Blades (Reference 10.7) section if
needed.
Avoid Corrosive Materials: Keep the mower away
•
from corrosive substances, such as fertilizer or rock
salt, as these can lead to rust and corrosion on
metal components like the blade, deck, motor, and
frame. Keep the mower and its battery away from
conductive or corrosive materials to reduce the risk
of short circuit, fire, explosion and other electrical
hazards.
•
Children Safety: Store the product in a location
inaccessible to children to prevent accidents.
•
Proper Covering: Do not cover the product with
a solid plastic sheet. Plastic coverings can trap
moisture, which causes rust and corrosion.
•
Check for Wear and Tear: Thoroughly inspect the
mower for any worn or damaged parts that may
require replacement.
21
EN
1
2
3
Publicidad
