Publicidad
Idiomas disponibles
Idiomas disponibles
16.1 ERROR CODE
Error
Description
Code
T2
Drive motor stalled
T5
Motor encoder error
T6
Controller phase loss
T7
MOSFET open circuit error
T8
Controller undervoltage
T9
Controller overvoltage
T12
Motor overtemperature
T13
Controller overtemperature
T15
Hardware overcurrent
T16
Accelerator error
T19
Operating sequence error
T23
Battery compartment (PMU)
communication failure
T24
Battery compartment (PMU)
failure
T31
Seat switch abnormal
T32
Software authentication error
T63
Drive motor temperature sensor
fault
M2
Drive motor stalled
M3
Motor low speed protection
M4
Motor overspeed protection
M6
Controller phase loss
M7
MOSFET open circuit error
M8
Controller undervoltage
M9
Controller overvoltage
M13
Controller overtemperature
M15
Hardware overcurrent
M19
Operating sequence error
English
Solution
Check if the drive wheels are stuck and restart the power supply.
Check that the connector of drive controller is properly connected,
and then restart the power supply.
Check that motor cables of the drive controller are connected proper-
ly, and then restart the power supply.
If you encounter this issue, contact your distributor for a solution.
The voltage is too low. Charge the battery before use.
The voltage is too high. Restart the power supply.
The motor temperature is too high. Wait for the motor to cool down,
and then restart the power supply.
The controller temperature is too high. Wait for the controller to cool
down, and then restart the power supply.
The load is too high. Restart the power supply.
Check that the accelerator of lever is connected properly, and then
restart the power supply.
Do not press the accelerator pedal when starting the product.
Communication failure with battery compartment. Restart the power
supply.
Minor/major error in battery compartment. Perform a check and re-
start the power supply.
Check that the connector under the seat is connected properly, and
then restart the power supply.
Restart the power supply.
Check if the 6-pin connector of the drive motor is properly connected.
If the error is not cleared after restarting, please contact your distribu-
tor for a solution.
Check if the drive wheels are stuck and restart the power supply.
Restart the power supply.
Restart the power supply.
Check that motor cables of the drive controller are connected proper-
ly, and then restart the power supply.
If you encounter this issue, contact your distributor for a solution.
The voltage is too low. Charge the battery pack before use.
The voltage is too high. Restart the power supply.
The controller temperature is too high. Wait for the controller to cool
down, and then restart the power supply
The load is too high. Restart the power supply.
Please restore the blade switch to its initial position. Check that the
grass-collecting switch is connected properly and if the grass catcher
or rear cover is pressing down on the grass collection switch. Sit on
the seat and try again.
33
EN
Publicidad
