Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10.4 RECOMMENDED MAINTENANCE SCHEDULES
Maintenance Service Interval
Before each use or daily
Before storage
After the first 100 hours
10.5 CHECK TIRE PRESSURE
For even mowing, it is crucial that all tires maintain the correct air pressure. Refer to the table below for the
recommended pressures.
Note: Measure or adjust tire pressure only when the tires are cold or haven't been recently driven.
Drive wheels
Front wheels
Note: Inspect the tires daily. Replace immediately if damaged.
Check the tire pressure carefully while inflating. Overinflating the tire may lead to a burst, resulting in severe
personal injury.
10.6 TORQUE VALUES
Particular attention must be given to tightening the drive wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade, which can cause serious damage and/or personal
injury.
Torque values are given below:
Part
Wheel lug nuts
Blade spindle bolts
Wheel lug nuts only: It is recommended that these be checked after the first 2 hours of operation initially, then every
100 hours and following removal for repair or replacement.
10.7 SERVICE THE MOWER BLADES
10.7.1 MOWER BLADE MAINTENANCE
Inspect the mower blades on a daily basis. They are crucial for power efficiency and optimal mowing. Ensure they
are sharp, as a dull blade can cause tearing instead of cutting, resulting in a brown and ragged appearance on the
English
Maintenance Procedure
•
Inspect the blades.
•
Check the tire pressure.
•
Check the contacts of switches and brakes.
•
Check for frayed and deteriorated insulations.
•
Clean under the cutting deck. Clean the area under the operator's seat
and near the battery. Remove all grass clippings, leaves, and debris from
the product before starting work.
•
Remove the battery and key fob from the product.
•
Perform all maintenance procedures and thoroughly clean the product.
•
Inspect the entire product for damaged, missing, or loose parts, replace or
tighten the corresponding ones before storage.
•
Paint chipped surfaces.
•
Check the wheel-lug nuts.
WARNING
WARNING
Ft-lbs.
66-73
115-118
24
14 psi
40 psi
N.m
90-100
155-160
Publicidad
