Eaton TRIPP-LITE CSC16USB Manual Del Propietário página 5

4. Setup
Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack or mount the
charging station without assistance. Use extreme caution when handling the charging station
and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the charging station.
4.1 Adjusting Storage Shelf Dividers
Your charging station comes with a
storage shelf containing adjustable
dividers that can accommodate up to
16 personal electronic devices.
Remove any personal electronic
devices stored on the shelf tray.
Then remove the blanking panel by
inserting your fingers into its left and
right holes, lifting the blanking panel
up and pulling out . To remove the
A
shelf tray from the cabinet, push the
shelf tray forward to disengage from
the mounting hook, then pull the tray
up and out. Once the shelf is
removed, remove or rearrange the dividers by pushing in the two tabs securing the divider to the rear end
the divider forward to disengage from the shelf tray
4.2 Powering the USB Charger/Hub Unit
Once the blanking panel has been removed as shown in Section 4.1, find the
USB Charger/Hub unit's input plug and cable located in the charging station's
bottom compartment. Then push the input plug through one of the power cord
access holes located on either side of the charging station cabinet
power cord access hole on the same side as the power cord manager is
recommended). Plug the power cord into the nearest 3-prong, grounded wall
outlet.
Note: The power cord can optionally be routed through the charging station's rear panel.
To do so, first remove the rubber grommet from either power cord access hole and
attach it to the cable lock routing hole on the back of the unit (see 3. Feature
Identification for routing locations).
4.3 Door Locks
The split doors contain a lock that is accessible with the included keys.
1
2
A
. Repeat as necessary for additional shelf dividers.
C
5
C
(using the
A
A
B
, then push
B