Eaton TRIPP-LITE CSC16USB Manual Del Propietário página 7

5. 16-Port USB Charger Hub
5.3 Connecting a Computer to the USB Charger/Hub
In addition to device charging, the USB Charger/Hub is equipped with a hub function that syncs devices and their
respective software applications via a connected computer. To enable the hub function, use the included USB cable to
connect the USB-B connector into unit's Computer Sync Port and the USB-A connector into a computer's USB port.
Note: When a computer connection is established and multiple devices are connected to the USB Charger/Hub, the charge rate will
reduce during syncing and resume to the normal charge rate upon completion.
Note: The Firmware Upgrade Port requires a mini-USB connection (cable not included). To download the most recent firmware
updates, go to tripplite.com/support.
6. Wall Mounting
For wall mounting, you will need:
• Level
• Appropriate tools for wall mounting
• Appropriate hardware for wall mounting (not included)
Warning: Do not attempt to mount the charging station to the wall with
any personal electronic devices inside.
There are 4 keyhole cutouts on the charging station cabinet's rear panel. Each
keyhole can accommodate an M5 or 3/16" bolt. Each of the keyhole sets are
centered 16" apart horizontally and 12" vertically (see the corresponding model
diagram for exact keyhole locations).
Using a level and tape measure, measure to position your mounting areas
precisely. Use appropriate fasteners (not included) to secure the charging
station to the wall.
Note: The charging station must be installed by a qualified technician. Use suitable
mounting means when installing to cinder block, concrete, drywall or wood studs.
Warning: The supporting surface must be able to safely support the combined
load of the charging station, equipment stored and all attached hardware and
components. See Section 8. Specifications for more information on your model's
weight and dimensions.
7. Desktop/Floor Placement
WARNING: For desktop and floor applications, always install the charging station in a structurally sound area with a level
surface that is able to bear the weight of the charging station, all equipment that will be installed in the charging station
and any other enclosures and/or equipment that will be installed nearby. Never attempt to lift or install the charging
station without adequate help. See Section 8. Specifications for more information on the charging station's rated load
capacity.
Note: The mounting brackets that shipped with the unit can also be used to secure the charging station to a desktop surface.
7
16"
12"