2.
For the second phase open the Service Door on the right side of the housing (gently pull
the unlocking device inside the handle upward, then gently remove the Service Door from
the housing). Unlock brewing unit (press red switch upwards and rotate the handle up and
to the left until it locks).
3.
Grasp handle and pull the brewing unit straight out to remove. Clean the brewing unit
under cold, running water and then let it dry. Put a brew unit specific cleaning tablet inside
the Brew Unit. Please observe the manufacturer's instructions of the cleaning tablet for
usage. Follow the instructions on the Display up to the end of the program and confirm
each time. The machine is ready for use again.
NOTE: Do not interrupt the cleaning programs while they are running.
EMPTY SYSTEM
This process empties the machine of any residual water and is recommended in case of long
term storage.
1.
Follow the instructions on the Display.
NOTE: Freezing residual water can damage the appliance. Avoid exposing the appliance to
temperatures below 32°F/0°C. Empty the system when the appliance is not used for a long
period, prior to transport and when there is a risk of frost.
DISASSEMBLE AND CLEAN FROTHER
From time to time, the frother must be disassembled completely and cleaned using water.
1.
Remove the front cover plate from the Dispenser, gently pull the frother down and then out
to the front and take it apart.
2.
Thoroughly clean the parts with soap, water and a reusable straw cleaning brush. Put the
frother back together. Insert the assembled frother back in the Dispenser.
3.
Reattach the cover plate to the Dispenser.
CHANGE WATER FILTER
The filter's effectiveness is used up after about 50 L of water has flowed through it.
A message/instruction to replace the filter appears on the Display.
1.
In the " " menu, select the Water Filter menu option. Select Yes so that the machine
detects that a filter is currently inserted. Select "Replace Filter".
2.
Using the mounting aid at the end of the Spoon, empty the Water Tank. Unscrew the old
filter from its holder and throw the filter away.
3.
Using the mounting aid at the end of the Spoon, screw the new filter into its intended
holder in the Water Tank.
4.
Follow the instructions on the Display up to the end of the program and confirm each time.
5.
The machine then heats up and is ready for operation again.
TERMS OF KITCHENAID GUARANTEE
("GUARANTEE")
Covering U.K. - Ireland - UAE
KitchenAid UK Limited Morley Way, Peterborough, Cambridgeshire PE2 9JB UK ("Guarantor") grants the end-customer, who is a
consumer, a Guarantee pursuant to the following terms.
FOR U.K.:
The Guarantee applies in addition to and does not limit or affect the statutory warranty rights of the end-customer against the seller of
the product. In summary, the Consumer Rights Act 2015 says products must be as described, fit for purpose and of satisfactory
quality. During the expected lifespan of your product your legal rights entitle you to the following:
� Up to 30 days: if your product is faulty, then you can get an immediate refund.
� Up to six months: if your product can't be repaired or replaced, then you're entitled to a full refund, in most cases.
� Up to six years: if your product does not last a reasonable length of time you may be entitled to some money back.
These rights are subject to certain exceptions. For detailed information please visit the Citizens Advice website
www.adviceguide.org.uk or call 03454 04 05 06.
10