Publicidad
Idiomas disponibles
Idiomas disponibles
EN
(Original instructions)
DESCRIPTION
A
Self-cleaning button
B
On/off button
C
Dry / Floor cleaning mode button
D
Power / Standard mode button
E
Pipe
F
Display panel
G
Sewage water tank unlocking key
H
Clean water tank
I
Sewage water tank
J
Charging base
K
Rolling brush
L
Power adapter
M
Cleaning brush
DISPLAY PANEL
Full sewage water tank
Self-cleaning mode
Clean water tank in shortage
Power cleaning mode
Cleaning mode (power/standard) indicator
Dry suction mode
Battery status:
Blue light > 20%
Orange light < 20%
Floor cleaner mode
Battery indicator
USE AND CARE:
Do not use the device if its accessories are not
properly attached.
Do not use the appliance if the accessories
attached to it are defective. Proceed to replace
them immediately.
Do not use the appliance if its start/stop device
does not work.
Do not use detergent that generates foam.
Do not use the appliance without placing the
dirty and clean water tanks correctly.
Store this appliance out of the reach of children
and/or people with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge.
Do not act on areas that contain metal objects
such as nails and/or screws.
Never vacuum up incandescent or sharp objects
(cigarette butts, ashes, nails...).
Do not use the device on pets or animals.
Keep the device in good condition. Check
that the moving parts are not misaligned
or stuck, that there are no broken parts or
other conditions that could affect the proper
functioning of the appliance.
HOW TO USE
NOTES BEFORE USE:
Make sure you have removed all packaging
material from the product.
Confirm that the device and all accessories are
included and correct.
Remove the clean water tank (H) using the
button (G). Open the lid and fill with clean water
to the maximum.
Replace the clean water tank in the body of the
appliance.
IMPORTANT: DO NOT add liquids with a
temperature higher than 60ºC. Fill only with
clean water.
ASSEMBLY OF THE DEVICE:
Place the tube together with the body until you
hear a "click".
To disassemble the tube from the body, use a
thin and hard object and proceed as indicated
in Fig.1.
Place the charging base on a flat and stable
surface and connect the charger to the hole on
the back of the base. Plug the charger into the
electrical network.
Place the device on top of the base as indicated
in Fig.2.
ROLLER ASSEMBLY:
To remove the roller from the shoe, follow the
steps as indicated in Fig.3.
To reinsert the roller into the shoe, follow the
previous steps in reverse.
USE:
To start cleaning, step on the shoe, pull the
handle back and upon hearing the locking latch
release sound, the machine will enter standby
mode (Fig.4).
Press the on/off button (B).
Press the button (C) to select the type of
cleaning (dry or wet).
Press button (D) to activate maximum cleaning
mode. Press this button again to return to
standard mode. This function is suitable for both
dry and wet cleaning.
The battery of the device is shown on the digital
display through the indicators (7) and (9).
Publicidad
