4. Installation instructions
2.
Push in and lock the 4FF (nano-SIM) SIM card in the slot
in the communication board. The SIM card contacts
must face the communication board.
4.5.4. Optional: Connect dynamic load balancing cable
Note
Use any network cable of Cat5 and above (Cat5, Cat5e, Cat6), with twisted paired wires.
•
The use of shielded network cable is recommended but not mandatory.
•
If a shielded cable is used, do not ground the shield.
•
For outdoor installations, use a UV stabilized network cable.
•
Network cables can have a pre-installed RJ45 plug, or the RJ45 plug can be installed before or after routing
the network cable into the charging station.
1.
If an RJ45 plug is not pre-installed, install an RJ45 plug
on the network cable.
EN
29