Pioneer SC-LX88-K Guia De Inicio Rapido página 3

Using Built-in AVNavigator
Connecting to the network through
LAN interface
Internet
Modem
Computer
LAN cable (sold separately)
LAN
(10/100) DC OUTPUT
for WIRELESS LAN
LAN
(OUTPUT 5 V (10/100)
0.6 A MAX)
Connecting to a wireless LAN
The wireless LAN converter can be connected to connect this
unit to a network wirelessly. Use the included AXF7031 for
connection.
Router
• Use only the furnished accessory connecting cable.
• Certain settings are required to use a wireless LAN
WAN
converter (AXF7031). For instructions on making these
settings, see the operating instructions included with the
LAN
wireless LAN converter (AXF7031).
1
2
LAN
( 10/100 )
DC OUTPUT
for WIRELESS LAN
3
( OUTPUT 5 V
0.6 A MAX )
DC OUTPUT
for WIRELESS LAN
( OUTPUT 5 V
0.6 A MAX )
Wireless LAN converter (AXF7031)
Plugging in the receiver
After connecting to a LAN, connect the power cord of the
receiver to a power outlet.
CAUTION
• Handle the power cord by the plug part. Do not pull out
the plug by tugging the cord, and never touch the power
cord when your hands are wet, as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, or other object on the power cord or pinch the
cord in any other way. Never make a knot in the cord or tie
it with other cables. The power cords should be routed so
that they are not likely to be stepped on. A damaged power
cord can cause a fire or give you an electric shock. Check
the power cord once in a while. If you find it damaged,
LAN (10/100) DC OUTPUT
for WIRELESS LAN
(OUTPUT 5 V
0.6 A MAX)
Modem Internet
Router
WAN
ask your nearest Pioneer authorized independent service
company for a replacement.
• Do not use any power cord other than the one supplied
with this unit.
• Do not use the supplied power cord for any purpose other
than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g., when on vacation.
• Make sure the blue uSTANDBY/ON light has gone out
before unplugging.
1
Plug the supplied power cord into the AC IN
socket on the back of the receiver.
2
Plug the other end into a power outlet.
Turning the power on
Press uSTANDBY/ON to switch on the receiver and your
computer.
Wait a few minutes after turning the power on before
performing the following operation.
SELECTOR
STANDBY /ON
3